Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN2000LS2 V6-3.0L VIN RREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSCAMSHAFT POSITION SENSORSERVICE AND REPAIR
2000 Saturn LS2 V6-3.0L VIN R
Camshaft Position Sensor: Service and Repair
2000 Saturn LS2 V6-3.0L VIN RSECTION Service and Repair
REMOVAL
1. Remove knock sensor wire from clip on CMP sensor.
2. Remove CMP sensor bolt.
3. Disconnect CMP sensor electrical connector.
4. Remove CMP sensor.
INSTALLATION
1. Install CMP sensor by gently pressing into place.
2. Install CMP sensor bolt.
Torque: 8 N.m (71 in-lbs)
3. Connect CMP sensor electrical connector.
4. Re-attach knock sensor wire to clip on CMP sensor.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.