Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN2000LS2 V6-3.0L VIN RREPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGCONTROL ASSEMBLYSERVICE AND REPAIRTEMPERATURE CABLE
2000 Saturn LS2 V6-3.0L VIN R
Temperature Cable
2000 Saturn LS2 V6-3.0L VIN RSECTION Temperature Cable
REMOVAL
1. Remove control head.
2. Remove R/H console closeout panel.
CAUTION: HEATER CORE PIPES MAY BE HOT!
3. Remove cable from module retaining clip using first two fingers to pull outward on cable while using thumb to spread retaining clip.
4. Remove cable from temperature door lever by squeezing end of pin and pulling cable eyelet outward.
INSTALLATION
1. Route new cable in through control head opening in I/P Cable housing flag goes to control head end.
2. Guide cable outward of I/P support brace.
IMPORTANT: Do not install cable housing into retaining clip at this time.
3. Install cable eyelet onto temperature door lever pin.
4. Install control head.
ADJUSTMENT
1. Place temperature control knob in full cold position.
2. Rotate temperature door lever fully forward and press cable housing into retaining clip.
3. Cycle control head temperature lever from full cold to full hot to verify proper operation.
4. Install R/H console closeout panel.
1. Remove control head.
2. Remove R/H console closeout panel.
CAUTION: HEATER CORE PIPES MAY BE HOT!
3. Remove cable from module retaining clip using first two fingers to pull outward on cable while using thumb to spread retaining clip.
4. Remove cable from temperature door lever by squeezing end of pin and pulling cable eyelet outward.
INSTALLATION
1. Route new cable in through control head opening in I/P Cable housing flag goes to control head end.
2. Guide cable outward of I/P support brace.
IMPORTANT: Do not install cable housing into retaining clip at this time.
3. Install cable eyelet onto temperature door lever pin.
4. Install control head.
ADJUSTMENT
1. Place temperature control knob in full cold position.
2. Rotate temperature door lever fully forward and press cable housing into retaining clip.
3. Cycle control head temperature lever from full cold to full hot to verify proper operation.
4. Install R/H console closeout panel.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.