Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN2000LS2 V6-3.0L VIN RREPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGCONTROL ASSEMBLYSERVICE AND REPAIRHVAC CONTROL HEAD INSTALLATION
2000 Saturn LS2 V6-3.0L VIN R
HVAC Control Head Installation
2000 Saturn LS2 V6-3.0L VIN RSECTION HVAC Control Head Installation
1. Rotate temperature knob to full hot position.
2. Install cable eyelet onto control head pin and install cable housing flag into slot in control head until it engages locking tab.
3. Install electrical connectors to control head.
4. Install control head to I/P screws.
5. Install radio electrical and antenna connectors.
6. Install radio to I/P screws.
7. Install radio trim bezel.
8. Enable SIR. (Refer to "Enabling SIR" procedure)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.