Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN2000LS2 V6-3.0L VIN RREPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGCONTROL ASSEMBLYSERVICE AND REPAIRBULBS
2000 Saturn LS2 V6-3.0L VIN R
Bulbs
2000 Saturn LS2 V6-3.0L VIN RSECTION Bulbs
REMOVAL
1. Remove control head.
NOTE: Use care not to touch bulbs with bare fingers.
2. Use small flat blade screwdriver to rotate bulb base counter-clockwise.
INSTALLATION
1. Use small flat blade screwdriver to rotate bulb base clockwise.
2. Install Control Head.
1. Remove control head.
NOTE: Use care not to touch bulbs with bare fingers.
2. Use small flat blade screwdriver to rotate bulb base counter-clockwise.
INSTALLATION
1. Use small flat blade screwdriver to rotate bulb base clockwise.
2. Install Control Head.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.