Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Saturn LS2 StandardFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) |
|---|---|
| Engine-To-Transaxle Bracket Bolt | 48 (65) |
| Flywheel-To-Crankshaft Bolt | 39 (53) |
| Lower Ball Joint Nut | 75 (100) |
| Master Cylinder Mounting Nut | 15 (20) |
| Pressure Plate-To-Flywheel Bolt | 11 (15) |
| Tie Rod End Nut | 33 (45) |
| Transaxle Mount Bolt | 41 (55) |
| Transaxle Strut-To-Midrail Bracket Bolt | 37 (50) |
| Transaxle Strut-To-Transaxle Bracket Bolt | 52 (70) |
| Wheel Lug Nut | 92 (125) |
| INCH Lbs. (N.m) | |
| Slave Cylinder Fastener | 89 (10) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.