2000 Saturn LS2 StandardFACTORY OEM SERVICE PROCEDURE

Torque Converter Clutch (TCC) Solenoid (Except 1.9L)

NOTE: Some solenoids may have an internal pressure switch in series with the solenoid winding and will not show continuity until transmission hydraulic pressure is applied.

Disconnect Torque Converter Clutch (TCC) solenoid harness connector. Using DVOM, measure resistance between appropriate TCC solenoid terminals. Solenoid resistance should be greater than 20 ohms.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.