Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Saturn LS2 StandardFACTORY OEM SERVICE PROCEDURE
DTC B1001: Option Configuration Error
- Turn ignition on. Using scan tool, monitor BCM DTCs. If scan tool displays DTC B1001, go to next step. If scan tool does not display DTC B1001, problem is intermittent.
- Turn ignition off. Wait 10 seconds. Turn ignition on. Using scan tool, monitor current or history DTCs. If scan tool displays DTC B1001 as a current or history DTC, use Service Stall System (SSS) and reprogram BCM with vehicle option content information. If scan tool does not display DTC B1001 as a current or history DTC, problem is intermittent.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
