2000 Saturn LS2 StandardFACTORY OEM SERVICE PROCEDURE

Content Theft Deterrent Programming

NOTE: Other options may be programmed using scan tool. See scan tool users guide for information.

There are 3 modes for content theft deterrent activation/deactivation. They are as follows:

  • Active

    Content theft will only be armed by using transmitter to lock doors.
  • Passive

    Content theft system will arm 5 minutes after ignition is off, all doors and trunk are closed. Any door opened will reset 5 minute timer.
  • Disabled

    Content theft system will not activate.

To enter programming mode, press PANIC button on transmitter 8-10 times in 5 seconds with ignition on. Within 3 seconds select mode by pressing appropriate button on transmitter. See MODE SELECTIONΒ  table. BCM will chime once when programming is complete.

MODE SELECTION

Transmitter Button Mode
LOCK Active
TRUNK Passive
UNLOCK Disabled
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.