2000 Saturn LS2 AutomaticFACTORY OEM SERVICE PROCEDURE

Programming Sensors

WARNING: This page is about a different car, the 2000 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition on. Press Driver Information Center (DIC) RESET button to clear any Instrument Panel Cluster (IPC) warning messages. Press DIC OPTIONS button until IPC display is blank.
  2. Press and hold DIC RESET button for 3 seconds. Press DIC OPTIONS button again until TIRE TRAINING message appears. Press DIC RESET button until IPC LEARN L FRONT TIRE message appears to begin programming sequence.
    NOTE: TPM Sensor Programming Tool (J 41760) is a large magnet.
  3. Install TPM Sensor Programming Tool (J 41760) over left front wheel valve stem. See Figure . Vehicle horn will sound, indicating TPM sensor is programmed. Proceed to next TPM sensor as directed by IPC messages.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.