Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN2000LS2 AUTOMATICREPAIR AND DIAGNOSISBODY & FRAMEPOWER MIRRORSSYSTEM TESTSTEST B: ONE MIRROR DOES NOT OPERATE IN ONE DIRECTION
2000 Saturn LS2 Automatic
Test B: One Mirror Does Not Operate In One Direction
2000 Saturn LS2 AutomaticSECTION Test B: One Mirror Does Not Operate In One Direction
- If mirror operates in up and down positions, go to next step. If mirror operates in left and right positions, go to step 4 .
- Remove power mirror trim panel of inoperative mirror. Disconnect power mirror motor harness connector. Connect a test light between terminals "B" and "C" at inoperative power mirror motor harness connector. See Fig 1 . Select inoperative mirror at power mirror switch. Move power mirror switch to right and left position. If test light is off in either position, go to next step. If test light is on in both switch positions, check mirror motor connector connections. If connections are good, replace inoperative power mirror motor. See POWER MIRROR MOTOR under REMOVAL & INSTALLATION.
- Check for and open or short ot ground in wiring between terminal "C" at power mirror harness connnector and power mirror switch harness connector. See WIRING DIAGRAMS . If problem exists, repair as necessary. If problem does not exist, check power mirror switch harness connector connections. If connections are good, replace power mirror switch. See POWER MIRROR SWITCH under REMOVAL & INSTALLATION.
- Remove power mirror trim panel of inoperative mirror. Disconnect power mirror motor harness connector. Connect a test light between terminals "A" and "B" at inoperative power mirror motor harness connector. See Fig 1 . Select inoperative mirror at power mirror switch. Move power mirror switch to up and down position. If test light is off in either position, go to next step. If test light is on in both switch positions, check mirror motor connector connections. If connections are good, replace inoperative power mirror motor. See POWER MIRROR MOTOR under REMOVAL & INSTALLATION.
- Check for and open or short ot ground in wiring between terminal "A" at power mirror harness connnector and power mirror switch harness connector. See WIRING DIAGRAMS . If problem exists, repair as necessary. If problem does not exist, check power mirror switch harness connector connections. If connections are good, replace power mirror switch. See POWER MIRROR SWITCH under REMOVAL & INSTALLATION.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.