Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN2000LS1 L4-2.2L VIN FREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSMANIFOLD PRESSURE/VACUUM SENSORSERVICE AND REPAIR
2000 Saturn LS1 L4-2.2L VIN F
Manifold Pressure/Vacuum Sensor: Service and Repair
2000 Saturn LS1 L4-2.2L VIN FSECTION Service and Repair
REMOVAL
1. Turn ignition Off.
2. Disconnect electrical connector from MAP sensor.
3. Remove attachment nuts for the throttle cable bracket. Pick up and move throttle cable bracket to the side. Remove MAP sensor. Remove port seal if retained in intake manifold.
INSTALLATION
1. Install MAP sensor and port seal into intake manifold.
2. Install throttle cable bracket and nuts.
Torque: 5 N.m (44 in-lbs)
3. Connect electrical connector to the MAP sensor. Push in connector until a click is heard and pull back to confirm a positive engagement.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.