Electronically Erasable Programmable Read Only Memory (EEPROM) Programming

2000 Saturn LS1 AutomaticSECTION Electronically Erasable Programmable Read Only Memory (EEPROM) Programming
  1. If Powertrain Control Module (PCM) was replaced, the EEPROM in the PCM must be programmed. If EEPROM is not programmed, a Diagnostic Trouble Code (DTC) will be set in the PCM or PCM may be damaged. Perform EEPROM programming using the Techline equipment manufacturer's instructions and latest software applicable for the vehicle model. Perform Vehicle Theft Deterrent (VTD) system auto learn procedure. See VEHICLE THEFT DETERRENT SYSTEM AUTO LEARN PROCEDURE.
  2. To verify proper EEPROM programming, start engine. If engine starts, go to next step. If engine fails to start, ensure all electrical connections on PCM are okay and all fuses are okay. Check Techline for latest software. Once engine is repaired so it will start, go to next step.
  3. Once EEPROM is programmed, use scan tool to clear DTC P0603 from PCM. Engine oil life interval and transaxle fluid life interval must now be reprogrammed. See ENGINE OIL LIFE INTERVAL PROGRAMMING. See TRANSAXLE FLUID LIFE INTERVAL PROGRAMMING.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.