Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN2000LS1 AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)SUSPENSIONWHEEL ALIGNMENTSPECIFICATIONS & PROCEDURESWHEEL ALIGNMENT SPECIFICATIONS
2000 Saturn LS1 Automatic
Wheel Alignment Specifications
2000 Saturn LS1 AutomaticSECTION Wheel Alignment Specifications
WHEEL ALIGNMENT SPECIFICATIONS
| Application | Preferred | Range | ||||||
|---|---|---|---|---|---|---|---|---|
| "L" Series | ||||||||
| Camber (1) | ||||||||
| Front | - 1 | - 1.75 To - 0.5 | ||||||
| Rear | - 1 | - 1.6 To - 0.4 | ||||||
| Caster (1) | 3.7 | 2.7 To 4.2 | ||||||
| Toe-In (1) | ||||||||
| Front | 0.2 | 0.04 To 0.36 | ||||||
| Rear | 0.3 | 0.13 To 0.47 | ||||||
| Toe-In (2) | ||||||||
| Front | 0.1 (2.5) | 0.02 To 0.18 (0.5 To 4.5) | ||||||
| Rear | 0.2 (4.0) | 0.06 To 0.24 (1.5 To 6.0) | ||||||
| "S" Series | ||||||||
| Camber (1) | ||||||||
| Front | - 0.5 | - 1.2 To 0.2 | ||||||
| Rear | - 0.7 | - 1.4 To 0 | ||||||
| Caster (1) | 1.7 | 1.1 To 2.3 | ||||||
| Toe-In (1) | ||||||||
| Front | 0.2 | 0.1 To 0.3 | ||||||
| Rear | 0.2 | 0.1 To 0.3 | ||||||
| Toe-In (2) | ||||||||
| Front | 0.1 (2.5) | 0.05 To 0.15 (1.5 To 4.0) | ||||||
| Rear | 0.1 (2.5) | 0.05 To 0.15 (1.5 To 4.0) | ||||||
|
||||||||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.