Electronically Erasable Programmable Read Only Memory (EEPROM) Programming

2000 Saturn LS1 AutomaticSECTION Electronically Erasable Programmable Read Only Memory (EEPROM) Programming
WARNING: This page does not describe the selected car, but rather 98 other vehicles, including the 2001 Saturn SW2, 2001 Saturn SL2, 2001 Saturn SL1, 2001 Saturn SL, and 2001 Saturn SC2. However, it is still accessible from the selected car via links, so may be relevant.
  1. EEPROM must also be programmed if replacing Powertrain Control Module (PCM) or changing Transaxle Control (TC) calibrations. If EEPROM is not programmed, a Diagnostic Trouble Code (DTC) will be set in the PCM.
  2. Ensure battery is fully charged. Ensure cable is properly connected on Data Link Connector (DLC). Perform EEPROM programming using the Service Stall System (SSS) equipment manufacturer's instructions and latest software applicable for the vehicle model.
    CAUTION: PCM may be damaged if programming procedure is interrupted during the downloading procedure. Ensure cable for scan tool is securely connected to SSS equipment and power supply for SSS is securely connected to power supply before proceeding.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.