2000 Saturn LS L4-2.2L VIN FFACTORY OEM SERVICE PROCEDURE

Crankshaft Position Sensor: Service and Repair

REMOVAL

Factory service manual diagram



1. Disconnect negative battery cable.

CAUTION: Make sure the vehicle is properly supported and squarely positioned prior to lifting. To help avoid personal injury when a vehicle is on a hoist, provide additional support for the vehicle on the opposite end from which components are removed. Make sure hoist does not contact fuel or brake lines.

2. Raise Vehicle on a hoist.
3. Disconnect two starter solenoid electrical connections.
4. Remove lower starter assembly to engine block bolt.
5. Remove upper starter assembly to engine block bolt.
6. Move starter right clearing engine block, then left and out of engine block (flywheel housing).

Factory service manual diagram



7. Disconnect electrical connections from CKP sensor.
8. Remove attachment bolt and CKP sensor.

INSTALLATION
1. Lubricate O-ring with clean engine oil.
2. Install CKP sensor in engine block.
3. Install CKP sensor attachment bolt.

Torque: 10 N.m (89 in-lbs)

4. Connect electrical connector to the CKP sensor. Push in until a click is heard and pull back to confirm a positive engagement.

Factory service manual diagram



5. Guide starter into engine block (flywheel housing).
6. Install starter mounting bolts.

Torque: 40 N.m (30 ft-lbs)

7. Connect two starter electrical connections.
8. Connect negative battery cable.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.