Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Saturn LS L4-2.2L VIN FFACTORY OEM SERVICE PROCEDURE
Cruise Control Switch: Service and Repair
REMOVAL
1. Remove screws from steering wheel shroud.
IMPORTANT: Cruise control switches must be removed from rear. Do not attempt to pry them out from front as damage to steering wheel may occur.
2. Push switches out from rear of steering wheel.
INSTALLATION
1. Install switches pushing them in place from front of wheel.
2. Install steering wheel shroud.
1. Remove screws from steering wheel shroud.
IMPORTANT: Cruise control switches must be removed from rear. Do not attempt to pry them out from front as damage to steering wheel may occur.
2. Push switches out from rear of steering wheel.
INSTALLATION
1. Install switches pushing them in place from front of wheel.
2. Install steering wheel shroud.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.