1999 Saturn SW1 StandardFACTORY OEM SERVICE PROCEDURE

Specifications Index

"S" SERIES SPECIFICATIONS INDEX

System Specification/Procedure
Air Conditioning
Service GENERAL SERVICING PROCEDURES
Torque TORQUE SPECIFICATIONS
Axle Nut/Hub Nut 148 Ft. Lbs. (200 N.m)
Battery CAPACITIES
Brakes
Bleeding Sequence BLEEDING BRAKE SYSTEM
Disc Brakes DISC BRAKE SPECIFICATIONS
Drum Brakes DRUM BRAKE SPECIFICATIONS
Torque TORQUE SPECIFICATIONS
Charging
Generator GENERATOR & REGULATOR
Torque TORQUE SPECIFICATIONS
Drive Belts
Adjustment DRIVE BELT ROUTING
Belt Routing BELT ADJUSTMENT
Engine Cooling
General Service Specifications COOLING SYSTEM SPECIFICATIONS
Radiator Cap Pressure 15 psi or specification stamped on cap.
Thermostat R & I NA
Water Pump R & I WATER PUMP
Engine Mechanical
1.9L SOHC
Compression ENGINE COMPRESSION
Oil Pressure 13 psi (.91 kg/cm2 ) at curb idle and 36 psi (2.5 kg/cm2 )
Overhaul OVERHAUL
Torque TORQUE SPECIFICATIONS
1.9L DOHC
Compression ENGINE COMPRESSION
Oil pressure 13 psi (.91 kg/cm2 ) at curb idle and 36 psi (2.5 kg/cm2 )
Overhaul OVERHAUL
Torque TORQUE SPECIFICATIONS
Fluid Specifications See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button.
Flywheel/Flex Plate Torque 59 Ft. Lbs. (80 N.m)
Fuel System
Pressure Specification 40-55 psi (2.8-3.9 kg/cm2 )
Fuel Pressure Test Procedure FUEL SYSTEM PRESSURE TEST (SATURN)
Ignition
Firing Order & Cylinder Identification
1.9L FIRING ORDER & CYLINDER IDENTIFICATION .
Ignition Wires (Resistance) HIGH TENSION WIRE RESISTANCE
Ignition Wires (Routing)
1.9L NA
Spark Plug
1.9L (AC 41-627 (VIN 7) Or AC 41-628 (VIN 8)
Gap .040"(1.0 mm)
Torque 20 Ft. Lbs. (27 N.m)
Starting
Starter STARTER
Torque 27 Ft. Lbs. (37 N.m)
Wheel Alignment
Adjustment Specifications WHEEL ALIGNMENT SPECIFICATIONS
Torque TORQUE SPECIFICATIONS
Wheel & Tire
Wheel Lug Nut Torque 103 Ft. Lbs. (140 N.m)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.