Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1999 Saturn SW1 AutomaticFACTORY OEM SERVICE PROCEDURE
Mil Inoperative: 3.8L
NOTE:
After any repairs are completed, perform On-Board Diagnostic (OBD) system check. See ON-BOARD DIAGNOSTIC (OBD) SYSTEM CHECK .
- Perform On-Board Diagnostic (OBD) system check. See ON-BOARD DIAGNOSTIC (OBD) SYSTEM CHECK . After performing OBD system check, go to next step.
- Using scan tool, check for DTCs. If any DTCs are present, diagnose DTCs. See DIAGNOSTIC TESTS in appropriate TESTS W/CODES article. If no DTCs are present, go to next step.
- Check fuses for PCM battery and ignition feed circuits. If fuses are okay, go to next step. If fuses are open, go to step 9.
- Attempt to start engine. If engine starts, go to next step. If engine does not start, go to NO START DIAGNOSIS in appropriate BASIC DIAGNOSTIC PROCEDURES article.
- Turn ignition off. Disconnect PCM harness connectors. Turn ignition on. Using a test light connected to ground, probe ignition feed circuit at PCM harness connector. See appropriate wiring diagram in WIRING DIAGRAMS article. If test light illuminates, go to next step. If test light does not illuminate, go to step 8.
- Using a test light connected to ground, probe battery feed circuit at PCM harness connector. See appropriate wiring diagram in WIRING DIAGRAMS article. If test light illuminates, go to next step. If test light does not illuminate, go to step 8.
- Check for poor PCM ground or PCM ground connection. Repair as necessary.
- Locate and repair open in PCM battery feed or ignition feed circuits. Repair as necessary.
- Locate and repair short to ground in PCM battery feed or ignition feed circuits. Repair as necessary.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
