1999 Saturn SL2 Automatic, MP6FACTORY OEM SERVICE PROCEDURE

Crankshaft Position (CKP) Sensor Short & Resistance Checks

  1. Set DVOM on 2000-ohm scale. Connect DVOM leads to CKP sensor connector located on side of engine block. Turn ignition off. Disconnect ignition control module harness connectors. Measure resistance between CKP sensor terminals at ignition control module connector.
  2. CKP sensor resistance should be 500-900 ohms. If resistance is not as specified, replace CKP sensor. If sensor resistance is within specification, go to next step.
  3. With CKP sensor installed in block, connect one DVOM lead to either sensor terminal at ignition control module. Touch other lead of DVOM to engine block. Continuity should not exist. If continuity exists, CKP sensor or circuit is shorted to ground and must be repaired or replaced.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.