Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1999 Saturn SC2 L4-1.9L DOHC VIN 7FACTORY OEM SERVICE PROCEDURE
Removal
Remote Control Door Lock (RKE) Module Removal:
1. Remove rear seat console inserts.
2. Remove rear seat center console fasteners.
3. Disengage seat cushion by pushing rearward, then upward at two front retaining locations to release the rear cushion from the retainers.
4. Slide the cushion from under the seat back guiding the seat belt buckle through the seat cushion and remove the seat cushion.
Remote Control Door Lock (RKE) Module Removal:
5. Pull firmly on right front lower garnish/sill molding to loosen clips.
Remote Control Door Lock (RKE) Module Removal:
6. Lower rear seat back.
7. Remove right quarter trim panel fasteners.
8. Remove right quarter trim panel
Remote Control Door Lock (RKE) Module Removal/Installation:
9. Disconnect Remote Control Door Lock (RKE) module connector.
10. Pull firmly on remote control door lock (RKE) module from the top to bottom, to disengage double side tape retainer.
11. Remove remote control door lock (RKE) module.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.