1998 Saturn SW2 AutomaticFACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Switches

SWITCHES

Component Component Location
A/C High/Low Pressure Switch In engine compartment, rear of underhood junction block.
Back-Up Lamp Switch (M/T) On right rear top of transaxle.
Brake Switch (Stop Lamp) On brake pedal support. See Figure .
Clutch Start Switch (M/T) On clutch pedal support. See Figure .
Coolant Level Switch In coolant reservoir. See Figure .
Cruise Control Switch In steering wheel. See Figure .
Driver Seat Belt Switch On driver's seat belt buckle assembly.
Low Brake Fluid Switch On master cylinder reservoir. See Figure .
Oil Pressure Switch On rear of engine, near oil filter. See Figure .
Park Brake Switch Under center console, bottom of park brake lever. See Figure .
Park/Neutral Position Switch (A/T) On right rear of transaxle. See Figure .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.