Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1997 Saturn SW1 AutomaticFACTORY OEM SERVICE PROCEDURE
Installation Procedure
- Install seal on mirror assembly.
- If equipped with right side power mirror, connect electrical connector.
- Install mirror assembly to door. Install nuts and tighten.
Tighten
Tighten the Outside Rear View Mirror Nuts 10 N.m (89 lb in).
- Install foam filler to door frame.
- Install mirror cable into trim panel and tighten set screw on manual mirror.
Tighten
Tighten the Manual Mirror Cable-to-Trim Panel Set Screw to 3 N.m (27 lb in).
- Install trim panel to door frame.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.