Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1996 Saturn SW2 AutomaticFACTORY OEM SERVICE PROCEDURE
Removal & Installation
- Disconnect negative battery cable. Disconnect connectors at ignition control module. See Fig 1. Disconnect spark plug wires from coil pack. Remove coil pack/ignition control module assembly. For ignition control module location, see COMPONENT LOCATIONS in SYSTEM/COMPONENT TESTS article. Separate ignition coil(s) from ignition control module (if possible).
- To install, reverse removal procedure. Tighten ignition control module mounting bolts/nuts. Ensure mounting bolt holes are clean of old sealant. Use NEW mounting bolts supplied with module. Tighten mounting bolts/nuts to specification. See TORQUE SPECIFICATIONS .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.