1995 Saturn SW2 AutomaticFACTORY OEM SERVICE PROCEDURE

Sir Coil Assembly: Notes

CAUTION: To center coil assembly, set front wheels in straight-ahead position before removing or installing coil assembly. If an off-centered coil assembly is installed, ribbon in coil assembly will break when steering wheel is turned. After coil removal, always keep ignition switch in LOCK position to prevent steering shaft from turning and causing coil assembly to be off centered.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.