1995 Saturn SW2 AutomaticFACTORY OEM SERVICE PROCEDURE

Manual Bleeding

CAUTION: Use only DOT 3 brake fluid from a clean, sealed container.
  1. Clean areas around reservoir cap on master cylinder. Ensure fluid reservoir is full. Keep reservoir at least half full during procedure. Reinstall reservoir cap. Attach transparent tube to rear bleed valve on modulator. Submerge other end of tube in clean container partially filled with brake fluid. Slowly open bleed valve 1/2 - 3/4 turn.
  2. Have an assistant press brake pedal slowly and hold in position until fluid flows from bleeder hose. Close valve. Release brake pedal.
  3. Repeat steps 1) and 2) for front bleed valve on modulator. See Fig 1 . Refill reservoir to FULL line with DOT 3 brake fluid.
    Fig 1: Locating Modulator Front Bleed Valve
    G95H15286Courtesy of GENERAL MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.