Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
A/C Request Signal
The air conditioner mode selector is mounted on instrument panel. This mode selector provides a simple "A/C request" signal which is monitored by the PCM. PCM uses this signal to determine control of A/C clutch relay (if equipped) and to adjust idle speed when A/C compressor clutch is engaged. On some models, PCM may also activate electric cooling fan when this signal is present. If this signal is not present on A/C-equipped vehicles, vehicle may idle rough when A/C compressor cycles. To check function of the A/C mode selector, perform functional check of A/C mode selector. See appropriate SYSTEM/COMPONENT TESTS article in the ENGINE PERFORMANCE section.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.