1995 Saturn SW1 AutomaticFACTORY OEM SERVICE PROCEDURE

Diagnostic Aids

Checking malfunction history on scan tester may help determine cause of intermittent code. Check tightness of all terminals and connectors.

When attempting to diagnose an intermittent problem, use scan tester to review supplemental diagnostic information. Supplemental data (scan tester MALF HISTORY) can be used to help duplicate an intermittent problem. Using Diagnostic Service Probe (12092782) allows voltage to be read on wires without disconnecting connectors. Normal TP sensor scan voltage should vary smoothly from 0.4 volt to 4.5-4.9 volts as throttle is moved from closed to wide open throttle.

Fig 1: Code 21 Schematic Throttle Position Sensor Signal Voltage High
G95B13954
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.