Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN1995SL1 AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEPOWER WINDOWSTESTINGTEST 4
1995 Saturn SL1 Automatic
Test 4
1995 Saturn SL1 AutomaticSECTION Test 4
- Disconnect left rear window switch connector. With ignition switch in RUN position, connect a test light between left rear window switch Dark Green wire connector terminal and Purple wire connector terminal. Press left rear window switch (on master switch) up then down.
- If light comes on in both directions, go to step 3). If light does not come on in both directions, check for open in Dark Green and Purple wires between master switch and left rear window switch. If wires are okay, replace master switch.
- Connect a jumper wire between left rear window switch connector Dark Green wire and Dark Blue wire (going to left rear window motor). Connect a jumper wire between left rear window switch connector Purple wire and Brown wire.
- Press left rear window switch (on master switch) up and down. If window motor operates, replace left rear window switch. If window motor does not operate, check for open in Dark Blue and Brown wires between left rear window switch and left rear window motor. If wires are okay, replace motor.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.