1993 Saturn SW1 AutomaticFACTORY OEM SERVICE PROCEDURE

Code 12, Anti-Lock Warning Light Or Traction Led Fault: Notes

ANTI-LOCK warning light should come on for a bulb check when ignition switch is set to RUN position. If ABS Control Module (ACM) does not detect a fault, warning light will go out after 3 seconds. ACM provides a ground path for warning light circuit to turn off warning light.

Traction LED should come on when ignition switch is set to RUN position. LED will go out after a few seconds if engine is not running. If engine is running, LED will remain on until traction switch is toggled or if traction system is disabled if ACM detects a fault. ACM provides a ground path for LED circuit to turn on LED.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.