SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN1992SL2 STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)SUSPENSIONWHEEL ALIGNMENTWHEEL ALIGNMENT SPECIFICATIONS & PROCEDURESADJUSTMENTSTOE-IN ADJUSTMENT (FRONT)
1992 Saturn SL2 Standard

Toe-In Adjustment (Front)

1992 Saturn SL2 StandardSECTION Toe-In Adjustment (Front)
NOTE: If front wheel toe-in requires adjustment, check and adjust rear wheel camber and toe-in and front camber and caster first.

Lock steering wheel in straight-ahead position. Loosen tie rod end lock nut. See Fig 1 . Loosen steering gear dust boot clamp(s) at tie rod end. Turn tie rod end to obtain correct toe-in. Tighten lock nut to specification. See TORQUE SPECIFICATIONS  . Ensure steering gear dust boot is straight after adjustment. Tighten dust boot clamp.

Fig 1: Adjusting Front Toe-In
G92H04582Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.