1992 Saturn SL2 AutomaticFACTORY OEM SERVICE PROCEDURE

Pcm Learn Mode

  1. The PCM will change transaxle shift points depending on driving conditions or changes in engine performance. If the PCM memory or vehicle battery is disconnected, the PCM must relearn the current operating parameters.
  2. Perform the following steps on a clear highway. Place mode select switch (located on center console) in NORMAL. With transaxle at normal operating temperature, place gear selector in "D4".
  3. Open throttle about 30 percent. Perform 10 complete 1-2, 2-3 to 3-4 upshifts.
  4. While coasting at 35 MPH (DOHC engine) or 40 MPH (SOHC engine), open throttle halfway to create a 4-3 downshift. Repeat this 5 times.
  5. Move gear selector to "D3". While coasting at 20 MPH (DOHC engine) or 30 MPH (SOHC engine), open throttle 75 percent to create a 3-2 downshift. Repeat this 5 times.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.