1992 Saturn SL2 AutomaticFACTORY OEM SERVICE PROCEDURE

Front Wiper Module/Motor: Installation

  1. Connect wiring to new motor and turn switch on. Turn off switch. This will place motor in PARK position. Place wiper motor onto control module. Position crank arm at 9 o'clock position and install on wiper motor shaft. Apply Loctite to crank arm attaching nut and tighten to 21 ft. lbs. (28 N.m)
  2. Partially install wiper module in vehicle. Connect wiring to motor and module. Install motor/module assembly. Tighten to 89 INCH lbs. (10 N.m). Turn switch on momentarily, then turn off. Wiper arm should be in PARK position with crank arm at 9 o'clock position. Connect washer fluid hose (if equipped). Install cowl trim panel. Install wiper arms.
  3. Rotate defroster nozzle into mode valve assembly and install screws. Ensure nozzle is attached on both sides of HVAC module. Install upper trim panel into clips at windshield. Install trim panel screws and screw caps. Test wiper operation.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.