Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN1992SC STANDARDREPAIR AND DIAGNOSISBODY & FRAMEPOWER WINDOWSREMOVAL & INSTALLATIONPOWER WINDOW MOTORINSTALLATION
1992 Saturn SC Standard
Power Window Motor: Installation
1992 Saturn SC StandardSECTION Installation
- Position the new motor to regulator backplate, and with the aid of a helper, install new rivets by collapsing or crushing the end of the rivet with a ball peen hammer. See Fig 1 .
- Once motor is secured to the backplate with two rivets, remove bolt securing the sector to the backplate and using an electric power source, rotate regulator in the desired direction to provide access to the remaining rivet.
- Once the remaining rivet can be removed, install new rivet.
- Install regulator. See WINDOW REGULATOR .
NOTE:
It will be necessary to grind a tooth off the sector gear (the side that does not contact driven gear) to gain access to the remaining rivet. Use a flat nosed rotary file to prevent damage to the regulator.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.