SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSAAB20109-5REPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTINFOTAINMENTAUDIO SYSTEM WITH NAVIGATIONADJUSTMENT REPLACEMENTCOMMUNICATION INTERFACE MODULE BRACKET REPLACEMENT
2010 Saab 9-5

Communication Interface Module Bracket Replacement

2010 Saab 9-5SECTION Communication Interface Module Bracket Replacement
Fig 1: Identifying Communication Interface Module, Bracket And Fastener
G09435302Courtesy of SAAB-SCANIA OF AMERICA, INC.
Callout Component Name
Preliminary Procedure 
  1. Disconnect the negative battery cable. Refer to BATTERY NEGATIVE CABLE DISCONNECTION AND CONNECTION .
  2. Remove the instrument panel upper trim panel, see INSTRUMENT PANEL UPPER TRIM PANEL REPLACEMENT
1 Communication Interface Module Bracket Fastener (Qty: 2) See FASTENER CAUTION .
2 Communication Interface Module
3 Communication Interface Module
4 Communication Interface Module Bracket
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.