Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Trailer Interface Control Module Scan Tool Output Controls
2010 Saab 9-5SECTION Trailer Interface Control Module Scan Tool Output Controls
| Output Control | Description |
|---|---|
| Left Trailer Tail Lamp | Commands the left trailer tail lamp ON and OFF |
| Left Trailer Turn Signal Lamp | Commands the left trailer turn signal lamp ON and OFF |
| Left Auxiliary Tail and Brake Lamp | Commands the left auxiliary tail and brake lamp ON and OFF |
| Left Rear Auxiliary Turn Signal Lamp | Commands the left rear auxiliary turn signal lamp ON and OFF |
| Left Tail Lamp | Commands the left tail lamp ON and OFF |
| Right Trailer Tail Lamp | Commands the right trailer tail lamp ON and OFF |
| Right Trailer Turn Signal Lamp | Commands the right trailer turn signal lamp ON and OFF |
| Right Auxiliary Tail and Brake Lamp | Commands the right auxiliary tail and brake lamp ON and OFF |
| Right Rear Auxiliary Turn Signal Lamp | Commands the right rear auxiliary turn signal lamp ON and OFF |
| Right Tail Lamp | Commands the right tail lamp ON and OFF |
| Trailer Brake Lamps | Commands the trailer brake lamps ON and OFF |
| Trailer Backup Lamps | Commands the trailer backup lamps ON and OFF |
| Trailer Fog Lamp(s) | Commands the trailer fog lamp(s) ON and OFF |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.