Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Parking Assist Control Module Reprogramming
2010 Saab 9-5SECTION Parking Assist Control Module Reprogramming
Do not reprogram the parking assist control module, unless directed by a service procedure, or a service bulletin.
- Connect a scan tool to the vehicle and access SPS. Refer to SERVICE PROGRAMMING SYSTEM (SPS)
- Perform the SPS function Parking Assist Control Module - Programming and follow the on-screen instructions.
- Clear DTCs after completing the programming procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.