Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Before Programming The Engine Control Module
2010 Saab 9-5SECTION Before Programming The Engine Control Module
NOTE:
DO NOT program a control module unless you are directed by a service procedure or you are directed by a General Motors LLC service bulletin. Programming a control module at any other time will not permanently correct a customers concern.
Ensure the following conditions are met before programming a control module:
- Vehicle system voltage
- There is no charging system concern. All charging system concerns must be repaired before programming a control module.
- Battery voltage is between 12-16 V. The battery must be charged before programming the control module if the battery voltage is low.
- A battery charger is NOT connected to the vehicle battery. Incorrect system voltage or voltage fluctuations from a battery charger may cause programming error or control module damage.
- Turn OFF or disable any of the following systems that may put a load on the vehicle battery:
- Twilight sentinel
- Interior lights
- Daytime running lamps (DRL). Applying the parking brake, on most vehicles, disables the DRL system. Refer to the Owner's Manual.
- HVAC systems
- Engine cooling fans, etc.
- The ignition switch is in the proper position. The scan tool requests that you turn the ignition ON with the engine off. Do NOT change the position of the ignition switch unless you are requested to do so.
- All of the following tool connections are secure:
- The connection at the data link connector (DLC)
- The voltage supply circuits
- DO NOT disturb the tool harnesses while programming. If an interruption occurs during the programming procedure, programming error or control module damage may occur.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.