Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Communication Interface Module Replacement
2010 Saab 9-5SECTION Communication Interface Module Replacement
NOTE:
- It is critical to use the service replacement Communication Interface Module (CIM) only in the vehicle for which it was ordered.
- Failure to perform the following procedures will result in a red LED, DTC(s) being set, and limited or incomplete OnStar® services
- An OnStar® button-press to the OnStar® call center is not required to complete the procedure.
- It may take up to 24 hours for OnStar® service to become fully activated after performing the procedures.
- Perform the following procedure only once. Repeat attempts of the procedure may result in a delay of the activation process.
- To fully activate an OnStar® module, both the setup and activation request procedures must be completed on all vehicles with AND without an active OnStar® subscription to insure the unit has been setup properly for the vehicle it has been installed into and also to update the OnStar® with the correct unit information.
- To initialize the Turn-by-Turn feature, the vehicle must first be driven 8-16 km (5-10 miles) in order to allow the system to self-calibrate the dead reckoning feature.
- Use of a J 2534-compatible diagnostic tool interface is required when performing the SPS supported OnStar® Setup and Activation (ONSU) procedure.
- On vehicles up-fitted with TTY capabilities, it is necessary to perform a power cycle of the OnStar® Interface Module (OTIM), and toggle the TTY mode after completing the CIM installation and setup procedures.
- Connect the scan tool to the vehicle.
- Connect the Techline Information System (TIS) terminal to the scan tool.
- Select the OnStar® Setup and Activation (ONSU) option using the service programming system (SPS).
- The default language for the new CIM is English. To change the language to French or Spanish, access the scan tool.
- Inform the customer that it may take up to 24 hours for the OnStar® service to become fully activated.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.