Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Liftgate Control Module Replacement
2009 Saab 9-7X V8-6.0LSECTION Liftgate Control Module Replacement
Liftgate Control Module Replacement
Removal Procedure
1. Remove the liftgate trim panel. Refer to Liftgate Trim Panel Replacement (Liftgate Trim Panel Replacement).
2. Disconnect the electrical connectors (3) from the module as necessary.
3. Remove the bolts that retain the module to the liftgate.
4. Remove the module from the liftgate.
Installation Procedure
1. Install the module to the liftgate.
Caution: Refer to Fastener Caution (Fastener Caution).
2. Install the bolts that retain the module to the liftgate and tighten to 10 Nm (89 in. lbs.).
3. Connect the electrical connectors (3) as necessary.
4. Install the liftgate trim panel. Refer to Liftgate Trim Panel Replacement (Liftgate Trim Panel Replacement).
5. Program the liftgate control module. Refer to Control Module References (Programming and Relearning).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.