Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Saab 9-7X V8-5.3LFACTORY OEM SERVICE PROCEDURE
Fuel Level Sensor Replacement
Fuel Level Sensor Replacement
Removal Procedure
1. Remove the fuel sender assembly. Refer to Fuel Sender Assembly Replacement (Service and Repair).
2. Push down the fuel level sensor pigtail electrical connector retainer (1) and remove the connector from the module cover.
3. Remove the fuel level sensor pigtail wires from behind the retainer (2) on the bucket.
4. Push in the fuel level sensor retainer (1) on the bucket.
Important: Note the orientation of the fuel level sensor float during removal.
5. Slide down the fuel level sensor and remove the sensor from the bucket.
Installation Procedure
1. Position the fuel level sensor to the bucket and slide the fuel level sensor up into position.
2. Ensure that the fuel level sensor is fully engaged by the retainer (1) on the bucket.
3. Install the fuel level sensor pigtail wires behind the retainer (2) on the bucket.
4. Connect the fuel level sensor pigtail electrical connector to the module cover and ensure that the retainer (1) if fully engaged.
5. Install the fuel sender assembly. Refer to Fuel Sender Assembly Replacement (Service and Repair).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
