2007 Saab 9-7X V8-5.3LFACTORY OEM SERVICE PROCEDURE

Electronic Throttle Control Module: Service and Repair



Throttle Actuator Control Module Replacement

Removal Procedure

Notice: Refer to Handling Electrostatic Discharge Sensitive Parts Notice.

Factory service manual diagram



1. Remove the bulk connector from the bracket, insert a small flat-bladed tool to disengage the clip.
2. Disconnect the instrument panel (I/P) harness electrical connector.

Factory service manual diagram



3. Disconnect the engine harness electrical connector.

Factory service manual diagram



4. Release the retaining tab on the side of the throttle actuator control (TAC) module (3).
5. Remove the TAC module (3) from the retaining bracket (1).
6. If necessary, remove the TAC module bracket nuts (2) and bracket (1).

Installation Procedure

Factory service manual diagram





Notice: Refer to Handling Electrostatic Discharge Sensitive Parts Notice.

Notice: Refer to Fastener Notice.

1. If necessary, install the TAC module bracket (1) and nuts (2).

Tighten the nuts to 9 Nm (80 in. lbs.).

2. Install the TAC module (3) to the retaining bracket (1).
3. Snap the TAC module (3) into retaining tab.

Factory service manual diagram



4. Connect the engine harness electrical connector.

Factory service manual diagram



5. Connect the I/P harness electrical connector.
6. Install the bulk connector to the bracket.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.