2007 Saab 9-7X V8-5.3LFACTORY OEM SERVICE PROCEDURE

Coolant Temperature Sensor/Switch (For Computer): Service and Repair



Engine Coolant Temperature Sensor Replacement

Removal Procedure

Notice: Use care when handling the coolant sensor. Damage to the coolant sensor will affect the operation of the fuel control system.

1. Turn OFF the ignition.

Factory service manual diagram



2. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).
3. Drain the cooling system below the level of the ECT sensor. Refer to Cooling System Draining and Filling (LL8) (Cooling System Draining and Filling)Cooling System Draining and Filling (LH6) (Cooling System Draining and Filling).
4. Lower the vehicle.
5. Disconnect the engine coolant temperature (ECT) sensor electrical connector (1).

Factory service manual diagram



6. Remove the ECT sensor.

Installation Procedure

Notice: Replacement components must be the correct part number for the application. Components requiring the use of the thread locking compound, lubricants, corrosion inhibitors, or sealants are identified in the service procedure. Some replacement components may come with these coatings already applied. Do not use these coatings on components unless specified. These coatings can affect the final torque, which may affect the operation of the component. Use the correct torque specification when installing components in order to avoid damage.

Notice: Use care when handling the coolant sensor. Damage to the coolant sensor will affect the operation of the fuel control system.

1. Coat the ECT sensor threads with sealer GM P/N 12346004 (Canadian P/N 10953480), or equivalent.

Factory service manual diagram




Notice: Refer to Fastener Notice.

2. Install the ECT sensor.

Tighten the sensor to 20 Nm (15 ft. lbs.).

Factory service manual diagram



3. Connect the ECT sensor electrical connector (1).
4. Refill the engine coolant. Refer to Cooling System Draining and Filling (LL8) (Cooling System Draining and Filling)Cooling System Draining and Filling (LH6) (Cooling System Draining and Filling).

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.