2007 Saab 9-7X V8-5.3LFACTORY OEM SERVICE PROCEDURE

Air Flow Meter/Sensor: Service and Repair



Mass Airflow Sensor/Intake Air Temperature Sensor Replacement

Removal Procedure

Important: Use care when handling the mass air flow (MAF)/intake air temperature (IAT) sensor. Do not dent, puncture, or otherwise damage the honeycell located at the air inlet end of the MAF/IAT. Do not touch the sensing elements or allow anything including cleaning solvents and lubricants to come in contact with them. Use a small amount of a non-silicone based lubricant, on the air duct only, to aid in installation.


Factory service manual diagram



1. Disconnect the MAF/IAT sensor electrical connector.

Factory service manual diagram



2. Loosen the clamps at the MAF/IAT sensor and the throttle body.
3. Remove the air cleaner outlet duct bolt.
4. Remove the air cleaner outlet duct.
5. Loosen the clamp attaching the MAF/IAT sensor to the air cleaner housing.
6. Remove the MAF/IAT sensor from the air cleaner housing.

Installation Procedure

Important:: The embossed arrow on the MAF/IAT sensor indicates the proper air flow direction. The arrow must point toward the engine.


Factory service manual diagram



1. Locate the air flow direction arrow (2) on the MAF/IAT sensor.

Factory service manual diagram



2. Install the MAF/IAT sensor on to the air cleaner housing.
Notice: Refer to Fastener Notice.

3. Tighten the clamp securing the MAF/IAT sensor to the air cleaner housing.

Tighten the clamp to 7 Nm (62 in. lbs.).

4. Install the air cleaner outlet duct.
5. Install the air cleaner outlet duct bolt.

Tighten the bolt to 10 Nm (89 in. lbs.).

6. Tighten the clamps at the MAF/IAT sensor and the throttle body.

Tighten the clamps to 7 Nm (62 in. lbs.).

Factory service manual diagram



7. Connect the MAF/IAT electrical connector.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.