Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Saab 9-7X L6-4.2LFACTORY OEM SERVICE PROCEDURE
Control Module: Locations
Transfer Case Control Component Views
Instrument Carrier Support, Lower Left
Instrument Carrier Support, Lower Left:
1 - Transfer Case Shift Control Module
2 - Instrument Carrier Support, Left Side
Transfer Case
Left Side Of The Transfer Case - Rear:
1 - Transfer Case Encoder Motor Connector
2 - Propshaft Speed Sensor - Rear
3 - Vehicle Speed Sensor (VSS)
4 - Propshaft Speed Sensor - Front
5 - C310
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.