Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Saab 9-7X L6-4.2LFACTORY OEM SERVICE PROCEDURE
Memory Positioning Module: Service and Repair
Memory Seat Control Module Replacement
Removal Procedure
1. Remove the 3 seat switch bezel screws. Refer to Driver Seat and Passenger Seat Adjuster Switch Bezel Replacement (Driver Seat and Passenger Seat Adjuster Switch Bezel Replacement).
2. Remove 4 nuts that attach the seat pan to the seat assembly.
3. Remove the clip from the front outboard seat pan stud. Discard the clip.
4. Lift the seat pan up in order to allow access to the seat control module retaining screw.
5. Remove the seat control module retaining screw.
6. Disconnect the electrical connectors from the seat control module as necessary.
7. Remove the seat control module from the seat assembly.
Installation Procedure
1. Align and install the locating tabs on the seat control module with the seat pan.
2. Connect the electrical connectors to the seat control module as necessary.
Notice: Refer to Fastener Notice (Fastener Notice).
3. Install the screw that retains the seat control module to the seat pan.
Tighten the screw to 3 Nm (26 in. lbs.).
4. Install the seat pan to the seat assembly.
5. Install the nuts which retain the seat pan to the seat assembly.
Tighten the nuts to 25 Nm (18 ft. lbs.).
6. Install the 3 seat switch bezel screws. Refer to Driver Seat and Passenger Seat Adjuster Switch Bezel Replacement (Driver Seat and Passenger Seat Adjuster Switch Bezel Replacement).
7. Calibrate the seat. Refer to Memory Seat Calibration (Procedures).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.