2007 Saab 9-7X L6-4.2LFACTORY OEM SERVICE PROCEDURE

Powertrain Management: Locations



Engine Controls Component Views

Upper Left Side of the Engine - Front

Factory service manual diagram



1 - Powertrain Control Module (PCM)
2 - Powertrain Control Module (PCM) C3
3 - Powertrain Control Module (PCM) C2
4 - Generator

Lower Left Side of the Engine

Factory service manual diagram



1 - Evaporative Emission (EVAP) Canister Purge Solenoid
2 - Starter
3 - Crankshaft Position (CKP) Sensor
4 - Knock Sensor (KS) 2 - Rear
5 - Knock Sensor (KS) 1 - Front

Right Side of the Engine - Front

Factory service manual diagram



1 - Mass Air Flow (MAF) / Intake Air Temperature (IAT) Sensor
2 - Camshaft Actuator Solenoid Assembly
3 - Camshaft Position (CMP) Sensor
4 - Engine Oil Pressure (EOP) Switch
5 - Heated Oxygen Sensor (HO2S) Sensor 1

Upper Right Side of the Engine

Factory service manual diagram



1 - Secondary Air Injection (AIR) Solenoid

Upper Right Side of the Engine - Rear

Factory service manual diagram



1 - Manifold Absolute Pressure (MAP) Sensor
2 - Throttle Body
3 - Engine Coolant Temperature (ECT) Sensor

Top of Engine

Factory service manual diagram



1 - Ignition Coil 1
2 - Ignition Coil 2
3 - Ignition Coil 3
4 - Ignition Coil 4
5 - Ignition Coil 5
6 - Ignition Coil 6
7 - Fuel Injector 6
8 - Fuel Injector 5
9 - Fuel Injector 4
10 - Fuel Injector 3
11 - Fuel Injector 2
12 - Fuel Injector 1

Right Side of the Transmission

Factory service manual diagram



1 - Heated Oxygen Sensor (HO2S) Sensor 2

Accelerator and Brake Pedals

Factory service manual diagram



1 - Instrument Panel Harness
2 - Accelerator Pedal Position (APP) Sensor
3 - Accelerator Pedal
4 - Brake Pedal
5 - Stop Lamp Switch

Left Front of Chassis

Factory service manual diagram



1 - Secondary Air Injection (AIR) Pump
2 - Secondary Air Injection (AIR) Pump Relay

Fuel Tank

Factory service manual diagram



1 - Fuel Tank Pressure (FTP) Sensor
2 - Fuel Pump and Sender Assembly
3 - Chassis Harness
4 - Fuel Tank
5 - Evaporative Emission (EVAP) Canister Vent Solenoid
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.