2007 Saab 9-7X L6-4.2LFACTORY OEM SERVICE PROCEDURE

Trim Height Specifications


Trim Height Specifications

Trim height must be verified and adjusted before aligning the vehicle.

Z Height Measurement

All 53 mm (2.09 in) ± 12 mm (0.47 in)

The Z height measurement determines the proper ride height for the front end of the vehicle. Vehicles equipped with torsion bars use an adjusting arm to adjust the Z height. Vehicles without torsion bars have no adjustment and may require replacement of suspension components.

Important: All dimensions are measured vertical to the ground. Cross vehicle Z heights should be within 24 mm (0.9 in).




D Height Measurement

All 110 mm (4.33 in) ± 4 mm 0.16 in)

The D height measurement determines the proper ride height for the rear end of the vehicle. There is no adjustment procedure. Repair may require replacement of suspension components.

Important: All dimensions are measured vertical to the ground. Cross vehicle D heights should be within 12 mm (0.5 in) for vehicles equipped with coil springs. Vehicles equipped with air suspension should be within 8 mm (0.3 in).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.