Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Saab 9-7X L6-4.2LFACTORY OEM SERVICE PROCEDURE
Keyless Entry Transmitter Battery: Service and Repair
TRANSMITTER BATTERY REPLACEMENT
REMOVAL PROCEDURE
1. Using a number 0 Phillips screwdriver, remove the screw (1) from the transmitter.
NOTE: When replacing the battery, use care not to touch any of the circuitry. Static from your body transferred to these surfaces may damage the transmitter.
2. Open the transmitter case.
3. Remove the battery from the transmitter.
IMPORTANT: Do Not use metal objects to remove battery
INSTALLATION PROCEDURE
1. Install the battery into the transmitter. with the positive side of the battery down.
2. Snap the front and back half of the transmitter together.
3. Install the screw (1).Ensure the screw (1) is fully driven, seated and not stripped.
NOTE: Refer to Fastener Notice.
4. Ensure the transmitter halves are tight to prevent moisture from intruding into the transmitter.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.