Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Saab 9-7X 4.2iFACTORY OEM SERVICE PROCEDURE
Data Link Communication DTCS
DATA LINK COMMUNICATION DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | DEFINITION |
|---|---|
| DTC B1000 | Electronic Control Unit (ECU) Performance |
| DTC B1004 | Keep Alive Memory (KAM) Reset |
| DTC B1007 | EEPROM Write Error |
| DTC B1009 | EEPROM Checksum Mismatch |
| DTC U0100-U0299 | Lost Communication With Engine/Powertrain/Transmission Control Module (ECM/PCM/TCM) |
| DTC U1000 | Class 2 Data Link Malfunction |
| DTC U1001-U1254 | The module uses a default value for the missing parameter |
| DTC U1300, U1301, or U1305 (4.2L) | Class 2 Data Link Low, Hight, Low or High |
| DTC U1300, U1301, or U1305 (5.3L) | Class 2 Data Link Low, Hight, Low or High |
| DTC U2100 | High Speed CAN Communication Bus |
| DTC U2105-U2199 | Lost Communication With Engine Control Module (ECM) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
