2006 Saab 9-2X F4-2.5LFACTORY OEM SERVICE PROCEDURE

Transmission Position Sensor/Switch: Adjustments

Inhibitor Switch

ADJUSTMENT
1. Move the select lever to "N" range.
2. Loosen the three inhibitor switch securing bolts.
3. Insert the ST as vertical as possible into the holes in inhibitor switch lever and switch body.
ST 499267300 STOPPER PIN

Factory service manual diagram




4. Tighten the three inhibitor switch bolts.
Tightening torque:
3.5 Nm (0.36 kgf-m, 2.6 ft. lbs.)

5. Repeat the above checks. If the inhibitor switch is determined to be "faulty", replace it.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.